See below to learn how to properly remove the bonnet off of the globe. You can also view a quick video here:
Turn off the Litter-Robot by pressin...
The Litter-Robot is equipped with an anti-pinch safety feature to make the Litter-Robot III Open Air extra safe for your cat.
While cycling, if a potential pinch condition is detected, the globe wi...
The Reset button is so named because it resets the cat sensor. You can think of the cat sensor as the scale and the Reset button as a way to zero the scale.
To reset the cat sensor, the Lit...
The Litter-Robot works best with either 12VDC unregulated 400mA to 1,000mA or 15VDC regulated 400mA to 1,000mA.
While the unit does not require a Litter-Robot power supply, you can order th...
8 Hour Sleep Mode allows you to deactivate the cat sensor for 8 hours so the Robot will not cycle automatically. Sleep Mode is useful for Litter-Robots located in bedrooms or areas where you may not w...
Below we will show you how to remove and replace the heavy-duty PVC black liner located inside the globe of your Litter-Robot 3. You can purchase a replacement liner on request from sales@catevolution...
SLOW FLASHING YELLOW (1 per second)
Cat sensor has been activated to interrupt the cycle, or the bonnet has disconnected or been removed.
What to do? Wait 15 seconds to see if the cycle resu...
BLUE FLASHING LIGHT
Waste drawer is approaching full.
What to do? Empty the waste drawer by removing the full liner. Put in a new liner, make sure it does not extend over the edge of the dra...
Either the cat wont leave the Robot, or there is too much weight inside.
What to do? Remove cat if inside. If no cat, empty the waste drawer and put in a new liner. Press RESET ...
LIGHTS FLASHING BLUE > YELLOW > RED
Cannot find dump position.
What to do? Robot should still cycle automatically, but you need to contact customer service for help
LIGHTS FLASHING R...
The amazing Litter-Robot III Open Air is the 3rd version of the Litter-Robot, which is made in USA. The Open Air was upsized for larger cats, such as Maine Coons and Rag Dolls, with the oval or ‘egg’ ...
To start off, you need to put about 4.5kg to 5kg of litter into the globe. There is a line marked on the liner, and you will need to check how much your chosen litter weights when the l...
For most cats, especially if they are good with using a manual litter tray, the Litter-Robot is a welcome addition to the home. Everyone loves a clean litter tray, and once your cat or cats understand...
A common question is which litter is best in the Litter-Robot III Open Air?
As a general guide in choosing a litter type, particularly if you need to change from your litter to a ...
A flashing blue light on the Litter-Robot III Open Air is the Drawer Full Indicator (DFI) sensor advising the waste drawer is full and needs to be emptied.
The DFI is located on the underside of th...
The Litter-Robot III Open Air has almost the same floor space as an extra large cat tray. However, it is taller.
Its important to check if it will fit where you would like it to go, rather than hav...
Showing 17 to 32 of 34 (3 Pages)